Reply to thread

Message

[QUOTE="TJC510, post: 1301099, member: 73205"]
Don, i have the fastway damper mount system on my 500, it is a very clean way to do both. the only issue i had is i cut my bars down to 30.5 and the bars are made to fit a 31.5 bar. all i did was snug the bar end, hit it with a hammer to get it to fit tight against the bar and tighten her up. i haven't had a problem with it sliding out, i tryed the same thing with my EE guards on my KTM, and they keep sliding out. it might be that the EE guard is more rigid. they both use the same taper lock in the bar. i had to drill a hole in the EE guard to get it to fit right.

i have not had a problem with my fastway shields, i did here they were having problems with them breaking especially in cold, but revised the molding process and shouldn't have a problem. i have bent mine backwards and it just shows the normal whitening. i also talked with fastway, they make all their stuff, but give cycra the rights to the probend. but it does look like the cycra shields would fit, the fastways are only missing one hole for the shield to mount.

the evolution mounts clear everything just fine.
[/QUOTE]

Verification

Which ocean is California closest to?