Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
quick help please, jetting a 2001 CR250
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="jdager, post: 1323301, member: 88869"] well, got the carb apart to check jets, and had a 30 pilot, 400 main, needle on second from top clip, havent checked air screw yet. what should I run to hopefully get rid of some of the low end bog, but more importantly keep from running too lean on top? thanks James, that was really helpful. one question though, when I loosen the boot retainers and try to rotate the carb, towards me, the throttle cable is too tight to let it rotate enough to get at the screws on top. any ideas on how to get around this, or am I just being an idiot? thanks, Jim [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
quick help please, jetting a 2001 CR250
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom