Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Race Teched 01 RM 250 Eastern setup?
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="rhyno, post: 376467, member: 32502"] Hi Jeremy, I have been playing with the valving on my 01 RM250 since I installed it june of 01. The problem: West Coast setup does not work in the tight woods of New England. Original setup would allow me to attack nasty downhills and 4th gear fireroads with confidence but when it comes to lugging around in tight trees and uphills that will not allow you to get out of 2nd gear my bike was horrible. Seemed like it wanted to bounce over the 6-8 rock or square edge roots. But as soon as I could get my speed up, like 3rd gear, my suspension would plushin up alot. I lowered fork oil level and softened highspeed but this made little difference. Forks were a bit plusher at lower speeds and a bit harsher at higher speeds. Pretty good but not great. As for the shock: I was told by RT to soften the high speed valving. I did this towards the end of 01 but this made little difference with the tight woods obstacles. It was still harsh at speeds lower that 3rd gear. Well I kept going softer with the high speed valving until it was bottoming on whoops and kicking me but the rear was still harsh on the 1st and 2nd gear nastiness. I did some talking with a guy from another site( I think it was offroad.com) and he suggested going faster with my HS rebound stack in my shock. I did this starting May 02 and it made a big difference on the 1st and 2nd gear obstacles. I also went 2 steps softer with my LSC. This made my bike handle much better on the 1st and 2nd gear stuff but now those 4or5 inch rocks on the high speed woods roads are scary. Its like the shaft speeds are not fast enough or something. What gives. Is this the limitations of RT gold valves or do I have to spend more time setting up my bike. oh one other thing. I have run Factory Connection suspension in the past and from there setup for eastcoast woods my bikes would never rip through whoops but it was super plush at lower speeds. I tried to explain this to RT but it fell on deaf ears. My RT setup with still rip through whoops but is not quite as plush as Factory Connection setups I have ridden. Is this type of obstacle something that can be used to fine tune my bike for the tight woods of New England. Thanks very much for any info you can give me. "A" NETRA Enduro rider. Probably being too anal about his setup. Not sure if that is possible though. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Race Teched 01 RM 250 Eastern setup?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom