Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Suzuki MX & Off-Road Dirt Bikes
Rm250
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="muddy226, post: 658663, member: 46421"] Does anyone know what things can cause a seize of the bottom end ( left side I think ), which caused the flywheel to get too hot to touch, and now the bearing rattles. I haven't got further than taking the engine out and the cylinder off yet, but on doing so there was a little water ( beads only ) inside the cylinder. I'm pretty sure its not head gasket. The engine has just been rebuilt due to gearbox problems, and had new main bearings, cylinder re-plate, piston etc. On first re-assembly and for running in I put a used piston in, and on taking this out to put the new one in there were chips off the top of one side, and it appeared that the re-platers had left a small ridge at the top which the piston struck. I filed this off ( mostly ) with a diamond file, and now there appears to be a small gap about a millimeter down from the top. However I didn't get all of it, and the new piston has a little chip as well. Where could the water come from ? any help much appreciated. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Suzuki MX & Off-Road Dirt Bikes
Rm250
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom