Studboy said:If you are short on cash just sand down the scratches so that there aren't any sharp raised points (they cause pre-ignition) and you will be fine.
Over time they will fill in with carbon.
griffbones said:Pro Circuit would be good for sure, but I'll just bet that Eric Gorr would be cheaper and do every bit as good of a job as Pro Circuit.
In fact I would have sent the whole top end to Eric, as most shops (dealerships) send these kinds of things out anyway, so you don't really know who is working on your parts.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?