Reply to thread

Message: [QUOTE="Morvo, post: 986597, member: 64644"] On my KX250 1995 model the float height should be between 14mm and 18mm. If it is out of this range then the way to adjust it is to: 1. Remove the carb 2. Remove the float bowl chamber (4 screws) 3. Set the carb upside down but at an angle so the float valve arm doesn't compress the needle valve 4. Whilst holding the fuel valve seat down measure the distance from the gasket base (where the float bowl chamber screws onto) and the top of the float. 5. If the float height is out of the specified range as mentioned above then remove the float assembly (remove pin and valve), and bend the arm where the fuel valve hangs off from either up or down, depending on what your measurement was. 6. Re-measure the float height again and adjust again if neccessary. 7. Re-bolt the whole carburetor back together again and try it out! [/QUOTE]