Forgive me in advance for this stupid question. I dont have the factory service manual yet. The little owners manual that came with the bike has instructions on how to change coolant, which I followed. However, I just noticed while flipping through the manual that in the section on break-in, it mentions bleeding the air out of the coolant system after a change. But there are no directions on how to do this in the owners manual.
So, I searched this site and found that there is a nut on the top of the cylinder that is used the bleed the system. I think i found the nut mentioned. So, do I start the bike, and then open up the nut to bleed the system? If not, how do I bleed the air out of the coolant system?
This is the first liquid cooled bike I have ever been around.
Thanks. :)