Reply to thread

Message

[QUOTE="Canmx120, post: 1214769, member: 68222"]
Ok, havn't posted on this in awhile but everything is hopefully going together today. My manual(on cd) that I ordered off **** never came so I still don't know torques and there's an o-ring on the clutch side of the crank that came off when I pryed the seal out and I'm not entirely sure where it goes. Now, when the main bearings are in do you have to do anything extra to make sure everything's square? or would they be fine once pressed all the way into place? And when installing the crankshaft(which I'm pretty sure on my bike both sides are pressed in) how should I do this? I understand using heat to enlarge the inner race of the main bearings and maybe even putting the crank in the freezer, but IF it wont just drop together how should I coax it into place? Would tapping the end of the crank(rubber mallet) to press it into place hurt it? Canadian riverglade national is this weekend and I really want it back together so I can ride the amateur day.
Thanks everyone, been lots of help so far just need a little more guidance.
[/QUOTE]

Verification

Which ocean is California closest to?