Reply to thread

Message: [QUOTE="Kaybeach007, post: 900929, member: 57466"] Andrew Speak to an engineering shop, I am sure that they will know the material. It cost me about R600 South African, that's about $120 Australian, $100 US for material and labour. That's about half of what it would cost for the full needle roller bearing kit here. Have the engineering shop first clean the steel bushes, if they are damaged, then machine the vesconite bushes to the new size. You can throw the rubber seals away too, just remember to regrease the bolt once a year, which is a simple excercise now. I timed the job a few weekends ago and did it in 6 minutes. Not quite good enough for F1 or NASCAR, but I did take a few gulps of beer in between. I'm sure that slowed me down. [/QUOTE]