Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Taking a machining class: part ideas
Reply to thread
Message
[QUOTE="SpeedyManiac, post: 1164129, member: 19453"] Thanks for the tip. Unfortunately I don't have access to the equipment to do any heat treating (I need an oven that goes a lot higher than 550°F). Right now I scrounged some 416 annealed bar stock that's looking like the prime candidate. I'd prefer cold rolled 304, but unfortunately I can't find any around here. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Taking a machining class: part ideas
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom