Reply to thread

Message: [QUOTE="Coolector, post: 740943, member: 48891"] [b]KDX cyl prep[/b] Sorry to barge in guys but I had a quick question, I'm going to be tearing down my 81KDX250 next week to replace the piston and rings ect, and I was wondering if the cyl was the plating or a sleeve, I was able to stick a magnet through the exaust port which was attracted to the cyl wall. Some people also said I should get the cyl machined due to the fact it may be oval, couldn't measurements take care of this. Thanks [/QUOTE]