Hi All:
Just put the head back on my '01 KDX220R. Torqued the head nuts to 23 ft/lb rather than the recommended 18 ft/lb. Should I take it back apart and put in a new head gasket and torque to 18 ft/lb or just leave it alone?
Leave it there. but from now on you'll have to torque at 23 all the time or until you change your nut and stud, you will see very soon if you have to replace the gasket just start the machine and leave your rad cap open, if you dont see any black buble comming out or excessive humidity out of tail pipe your OK jump on it and VRRRROOOOOOOOMMMMMMMMM!!!!!!!!!!!!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.