Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
General Moto | Off-Topic Posts
Trailer bearing puller?
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="junkjeeps, post: 1213970, member: 26555"] This may be a dumb question, but here goes. What is the difference between heating with an oven versus using a bearing warmer(the type that uses the laminated bar and hums)? Here at work we've also used a rosebud to heat bearings that were too big for the warmer. Not placing the flame directly onto the bearing, but close enough to generate heat well in excess of 300 degrees. I haven't seen any failure in bearings that we've done this to. We also don't pack them until they are installed. This may not be any real comparison because the bearings here are much, much bigger than a wheel bearing. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
General Moto | Off-Topic Posts
Trailer bearing puller?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom