Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
wheel bearing spacer
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="ericz103, post: 1256577, member: 71740"] I just took the back wheel off my 05 yz 125 and the spacer inside the hub between the two wheel bearings is loose and free inside. Is that very normal? The axle had to be hit out with a hammer, and there was definitily a lack of anything resembling grease on it. The wheel bearings themselves looked fine... and i never noticed any play in them...so what would you guys do? I will probably need a new axle bolt since I messed the threads up while hammering it out. But should I go ahead and put new bearings on and try get that spacer straight? If the bearings look fine can I just put the new axle through with that spacer being loose? Or is there away I can get that spacer tight in there again? Anyone know of cheap place for an axle? didn't see anything on rockymountainatv.com motosport.com or ebay... any help would be appreciated. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
wheel bearing spacer
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom