Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
General Moto | Off-Topic Posts
Which Handguards?
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="Smit-Dog, post: 669178, member: 25436"] I did not have to grind my EE bars down (purchased 1.5 years ago). They fit fine with standard Renthal CR-Hi bend bars, and even when I cut the handlebars down to 30.5" (although it was a tighter fit). I can't remember whether the inner mount attaches outside or inside the cross-bar. I agree, it would be nice if brush deflector holes were pre-drilled. The rational though is that some guys don't want to run brush deflectors, and this also allows you to use non-EE brush deflectors. I went a few thousands smaller on the drill bit for an extra snug fit. Call EE directly; I'm sure they will be able to help you out. Cut the stock grips off, and remove all remnants of grip rubber and glue. Might be a good time to upgrade to a metal throttle tube. When putting new grips on, skip the grip glue, and safety wire them on. Do a search for more details. Then go bust some bark! [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
General Moto | Off-Topic Posts
Which Handguards?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom