Reply to thread

Message: [QUOTE="yamikawi21, post: 1315636, member: 98600"] Tore her down today to get some measurements for new parts. Found that the piston ring had a 3/8" - 1/2" gap in it...its supposed to be like...no gap...right? Thats really the only thing that looked bad, except obviously the gaskets were worn and destroyed in removing the cylinder. (I didnt know the "top end" was so easy to remove/work on. After I failed at my fork seal attempt I was nervous for toying with the engine itself...but its Piece of Cake!) Thanks for your opinions everyone. Ill let you know after the new parts are in. [/QUOTE]