Wiseco HotRod bearing for KX310?

'00kx250spode

Member
Oct 21, 2000
197
0
I had Eric bore and port my KX310. I also had Jim at 2FastRacing rebuild the lower end and install a Wiseco Hot Rod crankshaft. Both companies provided excellent service and I couldn't be more pleased.

I'm going to replace the top end and, as part of the rebuild, I'd like to replace the piston pin bearing that resides in the top part of the crank.

Can I use an OEM bearing? I'm thinking I should be able to since the 310cc piston was made to fit on the OEM crank, but does anyone know for sure?

Thanks, Mark
 

marcusgunby

LIFETIME SPONSOR
Jan 9, 2000
6,450
2
All wisecos i know of use std little end bearings-they have to as they dont supply the bearing.
 

bclapham

LIFETIME SPONSOR
Nov 5, 2001
4,340
0
i bought a complete Wiseco top end kit with cometic gaskets from motosportoutlet, it comes with a Wiseco little end bearing. check the Wisecoweb site, they have a catalogue in pdf with numbers for rings clips pins bearings etc.

that said, i last ran a yamaha bearing with my wiseco piston and pin with no problems!
 

bclapham

LIFETIME SPONSOR
Nov 5, 2001
4,340
0
i kid you not mate! :thumb:

00kx250, i think either bearing will work fine, the bag says made in Japan, met bet they are one the same!
 

Attachments

  • bearing.jpg
    59.5 KB · Views: 126

yzeater

~SPONSOR~
May 21, 2001
1,996
0
Originally posted by bclapham
i kid you not mate! :thumb:

00kx250, i think either bearing will work fine, the bag says made in Japan, met bet they are one the same!

A bearing, and something to help you get your bearing...hehe
 
Cookies are required to use this site. You must accept them to continue using the site. Learn more…