Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Yamaha MX & Off-Road Dirt Bikes
YZ250 Timing
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="SKIDOOrider800, post: 1205510, member: 60380"] Hey Guys. Finally got parts and got my rebuild done. for some reason my stator was no longer attached to my bike. Reading over the manual basically says put the engine to 7 thou BTDC and line up the marks (mag and stator). I noticed this was about 2-3 mm off the marks where I can see it was set before, and it always seemed to run fine. I moved the stator plate in the CCW direction, essentially retarding the timing slightly as I understand. I'm just nervous about this procedure and wondering if i should go back to the previous setting, or if i am over complicating it. We didn't have the dial shaft, so we used a dial indicator on an arm magnetized to the frame. We took like 2 hours getting it exactly perfect. I guess for that little adjustment there shouldn't be much difference anyway? Thanks in advance for the help, SDR800 [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Yamaha MX & Off-Road Dirt Bikes
YZ250 Timing
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom