Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
crank shaft tool help
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="war child, post: 1329127, member: 100973"] yes i did notice a little pin in the grove were the piston sits and i put the ring to this, i forgot if that went to the back or the front now, i looked at the wisco site and i think that the two little holes go were i put them, it was a bit hard because i didnt take the top off the cylinder head, the cap with the coolent tube on bcos the bolts were already tourke wrench set so i left them on and just slid the lot over the piston and ring, i think it should be ok, will the engine tell me if its not the right way,if it starts and goes realy well,runs good, should i take it that every thing is ok [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
crank shaft tool help
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom