James,
I would appreciate your knowledgable opinion on my 2000 300mxc jetting for 300FT,50-1mx2t 94 octane. Ihad my slide cut to a 7,stock main175,stock45pilot and changed to nozi#2clip from top.
This all said, the bike runs much better on the nozi,but still sputters1/8 to 1/3 throttle but runs clean from 1/3 to wot. I guess i am asking should i waste my time with the noz needles, or get down to business and go with the straight tapered needle? I am not a perfectionist like most,I just want a good clean setup that will serve me well from 40 to 90 degrees. I probably should have left the slide alone, but do you think it will be usable if i go with your straight needle suggestions? Thanks for any input, and I'll try to post on holeshot if they will ever send my password. Thanks for your time!
I would appreciate your knowledgable opinion on my 2000 300mxc jetting for 300FT,50-1mx2t 94 octane. Ihad my slide cut to a 7,stock main175,stock45pilot and changed to nozi#2clip from top.
This all said, the bike runs much better on the nozi,but still sputters1/8 to 1/3 throttle but runs clean from 1/3 to wot. I guess i am asking should i waste my time with the noz needles, or get down to business and go with the straight tapered needle? I am not a perfectionist like most,I just want a good clean setup that will serve me well from 40 to 90 degrees. I probably should have left the slide alone, but do you think it will be usable if i go with your straight needle suggestions? Thanks for any input, and I'll try to post on holeshot if they will ever send my password. Thanks for your time!