Brit Chris
Member
- Aug 16, 2005
- 28
- 0
Hi All,
Hope your are all good
I'm looking for a bit of advise i have just taken the top end off of my bike and there is no exhaust valve set up ( power valve) i have tried in vane to get a power valve set up and i was just looking for advise as to if i plated and welded the ports where the power valve should be would it harm the engine. The bike runs fine and has plenty of power but i was wondering if i did the above it would give me even more power.
Thanks in advance
Chris :bang:
Hope your are all good
I'm looking for a bit of advise i have just taken the top end off of my bike and there is no exhaust valve set up ( power valve) i have tried in vane to get a power valve set up and i was just looking for advise as to if i plated and welded the ports where the power valve should be would it harm the engine. The bike runs fine and has plenty of power but i was wondering if i did the above it would give me even more power.
Thanks in advance
Chris :bang: