Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
Reusing main Bearings in a 2001 CR250
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="XXX Adrenaline Spo, post: 1315940, member: 87234"] Im going to replace them because id rather not worry about them but placing a side load on them during install and removal is almost inevitable even using the proper methods. Installing I froze the brgs and heated the cases then allowed to reach room temp then heated a slug and sat it on the inner races for a few seconds then dropped a frozen crank in and heated the slug again, rested it on the L side inner race and assembled the cases, During dissasembly using a case splitting tool (Automotive Harmonic Ballancer Puller) has to place side load on the brgs, Well thanks for yalls ideas but im gonna replace em anyways. Stuart [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
Reusing main Bearings in a 2001 CR250
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom