dcwilson

Member
Mar 22, 2002
42
0
I was racing a GP a couple of weeks ago and the course had a 1/4 mile drag strip connecting the off-road section to the MX tracks. I was racing so I just held the bike WFO all five laps. On the fifth lap the bike started makin a squeeking, scratching noise so I figured I damaged something in the top end.

I pulled her apart and found no smoking gun, no piston damage, cylenter looked like new, etc., but I replaced the poston,rings, wrist pin, top bearing and all gaskets since I had about 8 races on it and I was there.

I ran two 40 mile races after breaking in the bike per the service manual and everything seemed back to normal.

Sunday I was racing a qualifier and about two miles into it the race the noise started again. It seemed like I lost my low end power and at one point it stopped running...I thought it was siezed, but it was not. I restarted the bike and finished the first loop (32 miles). The bike ran fine, except I noticed a slight degrade in lower end power, that I thought was friction, but now I don't.

I wanted my points so after a quick samich I decide to ride the second loop (42miles). The noise went away and stayed away for the last 20 miles, and the low wnd power was back to normal. This low end power observation was very very slight.

I am thinking there is something wrong in the power-valve system...Any suggestions???
 

MX2_motorex

Member
Jan 7, 2003
124
0
Ive had a problem like this before while trail riding. Your brake bolt or a sproket bolt could have come loose and started eating away at somthing. Ether that your axles are bone dry or you have a bent brake rotor. Hope this helps.

Andrew,
 

dcwilson

Member
Mar 22, 2002
42
0
Nope! It still makes the sound when not rolling.

Originally posted by MX2_motorex
Ive had a problem like this before while trail riding. Your brake bolt or a sproket bolt could have come loose and started eating away at somthing. Ether that your axles are bone dry or you have a bent brake rotor. Hope this helps.

Andrew,
 

bclapham

LIFETIME SPONSOR
Nov 5, 2001
4,340
0
i would pull the head and check the PV etc. ive had one break on my 01yz250.

there are two threads on it somewhere, one in this forum and one in the basic repair Q and A forum
 
Top Bottom