H HondaBrat Member Jan 2, 2002 62 1 Sep 28, 2012 #1 does anybody know what clip position on the needle is stock setting. This this is a little too rich. Thanks Mike
does anybody know what clip position on the needle is stock setting. This this is a little too rich. Thanks Mike
E EYY Member May 22, 2010 159 1 Sep 29, 2012 #2 I'd assume the middle position. Since you think it is running rich, you could try dropping the needle (raising the clip) by one notch to start with and see if it runs better.
I'd assume the middle position. Since you think it is running rich, you could try dropping the needle (raising the clip) by one notch to start with and see if it runs better.
H HondaBrat Member Jan 2, 2002 62 1 Sep 29, 2012 Thread starter #3 Ok I will start there. Mixed it 32:1 lots of smoke and oil dripping. Picked it up on craigslist for $250.
Ok I will start there. Mixed it 32:1 lots of smoke and oil dripping. Picked it up on craigslist for $250.
H HondaBrat Member Jan 2, 2002 62 1 Sep 29, 2012 Thread starter #4 I checked the needle clip and it was on the top ring. I mixed some fuel 40:1, hope that helps.
H HondaBrat Member Jan 2, 2002 62 1 Oct 5, 2012 Thread starter #6 Lots of oil dripping out the pipe and sounds raspy from the middle to top end. I went from 32:1 to 40:1 and it's a little better.
Lots of oil dripping out the pipe and sounds raspy from the middle to top end. I went from 32:1 to 40:1 and it's a little better.