HondaBrat

Member
Jan 2, 2002
62
1
does anybody know what clip position on the needle is stock setting. This this is a little too rich.

Thanks
Mike
 

EYY

Member
May 22, 2010
159
1
I'd assume the middle position. Since you think it is running rich, you could try dropping the needle (raising the clip) by one notch to start with and see if it runs better.
 

HondaBrat

Member
Jan 2, 2002
62
1
Ok I will start there. Mixed it 32:1 lots of smoke and oil dripping. Picked it up on craigslist for $250.
 

HondaBrat

Member
Jan 2, 2002
62
1
I checked the needle clip and it was on the top ring. I mixed some fuel 40:1, hope that helps.
 

HondaBrat

Member
Jan 2, 2002
62
1
Lots of oil dripping out the pipe and sounds raspy from the middle to top end. I went from 32:1 to 40:1 and it's a little better.
 

Welcome to DRN

No trolls, no cliques, no spam & newb friendly. Do it.

Top Bottom