Reply to thread

Message: [QUOTE="yzflyer88, post: 1439913, member: 127454"] [IMG]http://i1368.photobucket.com/albums/ag163/yzflyer88/20141211_1731211_zps4a90acb7.jpg[/IMG] Throttle & Pump cables, going in the slide. [IMG]http://i1368.photobucket.com/albums/ag163/yzflyer88/20141211_1724541_zpsf45b5bd5.jpg[/IMG] Assembled. [IMG]http://i1368.photobucket.com/albums/ag163/yzflyer88/20141211_1725321_zps4bb59105.jpg[/IMG] "Slack" to play with. [IMG]http://i1368.photobucket.com/albums/ag163/yzflyer88/20141211_1736191_zps0d8ca6af.jpg[/IMG] another shot of the throttle slack. [IMG]http://i1368.photobucket.com/albums/ag163/yzflyer88/20141211_1753291_zps3a1ab8a3.jpg[/IMG] Pump, with cable attached. Hard to see, but its only letting it return to the starting point about 1/4 of the way. [IMG]http://i1368.photobucket.com/albums/ag163/yzflyer88/20141211_1753561_zps015eb116.jpg[/IMG] This is the final result for the choke, and the throttle. haven had any problem with the choke, it being a independent line. But the throttle, that isn't enough slack to connect the slide and needle to it, and that is all the slack it is giving. This work here is done from the front of the bike, working towards the rear while. I do not have the cable attached to the twist throttle, because I am trying to get max slack I can. But, if I were to get this to work, I bet it would come up short on the twist throttle. I don't understand.....every throttle cable I have looked at for a pw50 is the same since the 80's.....would I be better off trying to get the single throttle line installed, or does someone know where I am messing this up? Thanks In Advance. Have a good night. [/QUOTE]

Verification: Which ocean is California closest to?