Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
97 CR80 Rear Hub Worn - Suggestions?
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="darringer, post: 846859, member: 26849"] rikhek, I used jb weld type epoxy on a rear hub on my 250 2-3 years ago and it worked very well. Did exactly what you said... New bearing, heated the hub to enlarge it a bit, put a little epoxy in the hub to build it up, force new bearing in, let cure. It worked very well. Also note that after the bearing has been in for awhile that you can use a seal pick to remove the rubber seal from the bearing and re-grease it while it's still epoxied in the hub, making it last indefinitely. I never had any trouble with the hub afterwards. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
97 CR80 Rear Hub Worn - Suggestions?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom