Reply to thread

Message: [QUOTE="Hart89, post: 994361, member: 63986"] Hey. Thanks for all the help on this. Its been so hot here so i was putting of going down to the shed to work on the bike but I finally got off my butt and pulled the clutch cover off. And what should i see but two clutch basket tabs/fingers floating round. So just imagining how expensive a new clutch basket will cost i remember seeing a TS90 engine sitting in my uncles shed under a pile of dust. This is the same uncle that gave me this TS185 and the IT400 ill be getting after christmas thanks too a mates brothers working out in that part. Anyway does anyone know if the small TS runs the same transmission as the 185 so i can chuck that in the ute with the IT? But seeing i'm an impatient son of a..and don't want to wait that long til i can ride i was thinking maybe put some new main bearings in and ride it with the stuffed clutch basket until i can or if i can use the 90's. Without doing race starts and the dumping of the clutch do you think it will hold? and what damage could it cause if it decided to go? Worst case scenario. I tryed shifting the gears and they seemed to change fine. i'm still scared that if i put it back together it will not work but it'll be less hassle then swapping bits of transmission around. I've been building a 40 foot step down and a 20 foot step up over the last couple of months so am craving to hit it on the old gal although with the absolute poo suspension ill probably die a terrible death. Thank-you for any help or advise you send my way [/QUOTE]

Verification: Which ocean is California closest to?