changing from 32mm to 35 mm carb...

Good afternoon,

I have a question concerning swapping carbs... I have a 1992 KDX250SR (not exactly the same as the US version)... I have the jetting sorted out pretty well using the stock 32mm PWK carb. I recently acquired a 35mm PWK from "that" auction site... I'm looking for recommendations for a starting point for jetting the "new" carb before I install it.

For instance... should I go up one or two jet sizes on the main and pilot? Use the same slide and needle that I have now? I'm just looking for some ideas or thoughts to get me started...

Thanks!