SilverSurfer
Member
- Mar 28, 2006
- 29
- 0
evenslower said:Powervalve linkage hooked up correctly? Sounds like PV not opening. Are you sure the fork on the bottom of the actuator arm that runs up the cylinder is aligned properly on the pin in the bottom end. If I remember right they are almost 90 deg to each other when connected properly.
Check to make sure everything is tight too and no PV flapping is going on.
I think there is some good info there. Good luck.
nickyd said:repack the silencer
evenslower said:Are you sure its opening all the way? I know from experience that center flap can get carbon build up in the slot that stops it from travelling through its full range.
Aside from that ignition????
2-strokes-4-life said:there is no test for the cdi unit.when diagnosing an ignition problem if all other components test out fine,that usually means the cdi is at fault
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?