Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
CR250 96 Stock clicker settings - Help !
Reply to thread
Message
[QUOTE="txkawboy, post: 890060, member: 48628"] Craig, Rebound is the little brass screw in the top, and Comp is the little screw underneath the rubber plug, on the very bottom of the fork leg. I am unsure what stock is, but usually ~middle on both C and R is "stock"...follow the general guidelines that Eric Gorr has on his site and u should be fine. FYI: once u start getting a little speed over abrupt, short, edged-type obstacles, that shock WILL kick pretty badly upon rebound, (unless it has been re-valved), so don't worry about trying to completely cure that malady, when you finally experience it. I have two f these bikes, but have the front and rear doen one both, and Race Tech std gold valves in the f and r onf one, as well. The g-valves are veery nice...once u get fast enuff to need it, I recc' them. EXCELLENT bike choice, btw! [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
CR250 96 Stock clicker settings - Help !
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom