Cr250 running better

[OriginalRider]

So i took at break from the bike. It was hard but i did it. I ordered the jd jetting kit and can't wait to get it installed. I'm hopeing this is gonna make a big difference seeing as the low end on the bike is pretty much gone. Can't wait to try this jd kit. Also if anyone knows of any graphics for this bike i have some Ceet graphics but can't seem to find any. I need the graphics for the tank and the wings.


Chad

you can find graphic kits at rocky mountain.im going to get the one industries

 

[zomiemama]

you can find graphic kits at rocky mountain.im going to get the one industries

Hey can u send me a link? I can't seem to find it.


Thanks

 

[helio lucas]

http://www.rockymountainatv.com/home.do;jsessionid=225DA8AB05387377D6B4B08D2473628A.westring1

 

[zomiemama]

Hey

I don't see anything on there Original Rider. I put in 1988 Cr250... mabye could you send me the link for what your looking at? Also i recieved the JD Jetting kit and it came with 178 as the largest main. I called them and there sending me a 180... Do you think i would be ok throwing in the 178 or should i wait for the 180?


Chad

 

[_JOE_]

The main won't effect the low end.

 

[zomiemama]

What would be a good set of reeds for this bike?

 

[TRexRacing]

I like Tony Doukas Epoxy Reeds.Not the carbon fiber bling.You have to look hard for them but you need a #66 reed for an '88 CR250.Should cost about $30 US.TDRs phone number is 800-321-6354.I run TDR reeds in my RZ350.It's just the reeds themselves,you use them on your stock cage.Try 'em you'll be surprised how much $30 gets you.