So I bought a new sprocket kit for my '97 YZ 125. Everything has been taken off and I'm just waiting for the kit to get here tommorow.
First of all, when I went to go loosen the front sprocket nut, it wasn't on there very tight... it didn't take much torque to get it loose. Is this normal?
Secondly, obviously I had to take out the rear axle to get the rear sprocket off. What should I re-grease the axle with? Or does it not need to be re-greased?
Thirdly... since taking my rear wheel off, what needs to be "reset" when putting it back on? Stupidly, I didn't look at what I had it set at before removing it. Is there a standard setting, or am I just going to have to do some trial and error?
First of all, when I went to go loosen the front sprocket nut, it wasn't on there very tight... it didn't take much torque to get it loose. Is this normal?
Secondly, obviously I had to take out the rear axle to get the rear sprocket off. What should I re-grease the axle with? Or does it not need to be re-greased?
Thirdly... since taking my rear wheel off, what needs to be "reset" when putting it back on? Stupidly, I didn't look at what I had it set at before removing it. Is there a standard setting, or am I just going to have to do some trial and error?