Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Fork pre-load
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="KXTodd, post: 428145, member: 20705"] Could somone please help me understand how to set the preload on my forks :( I got new springs from Race Tech and the instructions say= Once set length is recorded(measured from washer at cap to where spring sits inside w/rod fully extended)measure length of spring and subtract. This would equal the size spacer for 0 preload then add amount of preload needed including washers for each end to make spacers. OK , set length is= 466mm The springs themselves are =472 So...466-472= -6 I want to have 10mm preload , so do I need 16mm combined spacers and washers to accomplish this??? :think: I know I'm brain dead, please help the needy :confused: I'm soooooo confused because right now there is one spring at 465 w/a 6mm spacer and the other at 475 w/no spacer, WTF? [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Fork pre-load
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom