eddie1

Member
Oct 17, 2007
39
0
ok manual says run 20:1 and mix 250ml into 5 gallions to run at 20:1

online calulators say to use 920ml(+/-).


sad thing is i just fallowed the manual and mixed 250ml with 93 octane gas. Did I just ruen a brand new motor?

or is my manual right?
 

dirt bike dave

Sponsoring Member
May 3, 2000
5,348
3
What bike do you have?

If you have 250 ml of oil and you want to run it at 20:1, you will want to put the oil into 5 liters of fuel, not 5 gallons.

Looks like you were running about 77:1 or so.

If you did not push it hard and only rode a short time and you used a good quality oil, you might be OK.
 

eddie1

Member
Oct 17, 2007
39
0
i only rode this for break in period yet agin just my luck........well i just mixed the right oil and fuel should i be ok now?
 

dirt bike dave

Sponsoring Member
May 3, 2000
5,348
3
Mostl likely you will be fine.

FWIW, on a long trail ride with my KDX200, my buddy and I got lost. We were a long way from our camp and found a camper way out in the middle of nowhere. We each got straight gas from him for our two strokes (no other options available). I figure we were running about 100:1 for maybe 20 miles. We were careful not to use any more throttle or fuel than necessary. The bikes showed no ill effects.
 

CarnageZ28

Member
Mar 25, 2008
109
0
FWIW - It probably took some hours off the life of the top end, BUT many 2-Stroke aircraft engines are commonly mixed at ratios as thin as 100:1.
 

Welcome to DRN

No trolls, no cliques, no spam & newb friendly. Do it.

Top Bottom