Reply to thread

Message: [QUOTE="AV8R, post: 1303231, member: 66464"] If I understand you correctly the bearing on the clutch side is not tight? If that is the case try using Locktight sleeve retainer (green). You will need to first clean the area VERY well then prep it with locktight surface prep. Then put a very thin coat of the green stuff on the outer surface of the bearing or the inner surface of the case. Use a Q-tip or something similar so you don't contaminate the surface with your finger. Intall the bearing and wait overnight before re-assemblying the rest of the motor. I used this on the bearings on my rear hub and to this day (1 year later) they are still holding. [/QUOTE]