scottiedawg66 said:i usually just get it up to temperature, revit (not pin it, just rev it up and down) up to full operating temperature let cool and repeat three times (three heat cycles). then wheelie time!
Probably. This question comes up pretty regularly. Not as often as jetting or oil/gas ratio.Joburble said:Didn't someone cover all this a couple of months ago on here, ....
tank_tech said:is there a search page on this site, im sure im just missing it. or can someone direct me to one of these multiple threads on breaking in motors?
Joburble said:Didn't someone cover all this a couple of months ago on here, or maybe in Canadian Dave's KDX forum. I think someone posted a very good article about running the motor in quite hard and not nursing it. It was excellent reading with lots of studies done.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?