Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
How to lower the sub frame on my 03 CR250?
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="slyracing, post: 856617, member: 56134"] you can lower any bike who have dog-bone type junction between pivot link and swing-arm simply cut the dog-bone in middle and add 1/4 of inch of a steel flat bar who it`s the same thinkness of the dog-bone and weld it ,whit tig or mig welder,you could reinforce the dog-bone by adding small piece of steel flat bar each side of the dog-bone.this should be lower your bike between 1 1/2 to 3 inch according to the swing-arm/shock ratio and don`t forget to raise the front fork leg into the triple clamp as much as you could to balance the bike. this is no expensive and you could still bought new dog-bone to put it stock again longer is the dog bone lower is the seat,but don`t go more than a 1/2 of inch. i did that on lot of kdx and kx and on several custom roadbike. p.s dog-bone must be in steel may be to risky whit alu one [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
How to lower the sub frame on my 03 CR250?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom