I Give Up!

[andrewbugg10]

Just put a new seal in, kept the valve cover off to see if the valves open, i kicked the bike 8 times on a brand new plug, No go, put a old plug in kicked 3 times, no go, then i push started it 5 times and it finally fired up, i was in neutral reving after warming up and once i get at about 3/4 to full throttle the valves move so i dont think its them, it still has lack of bottom end, like i put my front tire up agaisnt a snowbank and tried to spin the wheel and it just went Blaaa blaa blaa then quit, didnt even try to spin it....i dunno anymore... im pissed

took the plug out its a bit black and oily but i dunno, i think its either Top End , Jetting or GOING IN THE GARBAGE CAN!

 

[andrewbugg10]

:whiner: the bike is a 1989 CR125

 

[TravisP]

is the power valve govenor assembled correctly?

 

[a454elk]

Check your reeds as well, they may be chipped or damaged. Clean out your carb completely and make sure you are using the right plug range and it sparks good.

 

[oldguy]

andrew what valves are you talking about?