JR 50 tube replacement

S

sammo39

Member

Jan 11, 2005

4

0

• Jan 11, 2005

• #1

I just bought a 97 JR 50 and am in the process of replacing the tube in the rear tire. The new tube came with a beveled washer and two nuts on the valve stem. The old one did not have this, so I need to know how they are installed when replacing the tube. Does the beveled washer and nut go inside the rim and the second nut attach to the outside of the rim?

 

oldguy

Always Broken

Dec 26, 1999

9,411

0

• Jan 11, 2005

• #2

on the outside and just one nut would be plenty- second is to lock it so it doesn't vibrate off

 

S

sammo39

Member

Jan 11, 2005

4

0

• Jan 11, 2005

• Thread starter
• #3

Thanks for the help. What about the washer, does it go on the outside as well?

 

oldguy

Always Broken

Dec 26, 1999

9,411

0

• Jan 11, 2005

• #4

Yes

 

S

sammo39

Member

Jan 11, 2005

4

0

• Jan 11, 2005

• Thread starter
• #5

Many thanks OldGuy.
sammo39

 

High Lord Gomer

Poked with Sticks

Sep 26, 1999

11,788

35

• Jan 12, 2005

• #6

I always leave one nut on the stem inside the rim. The nut on the outside should not be tightened. If you tighten it, if/when the tire slips on the rim, it will rip the valve stem out of the tire. With the outer nut loose, the valve stem will bend to front or back and you can notice, let the air out of the tire, and reposition before it rips the valve stem out of the tube.

 

Vic

***** freak.

LIFETIME SPONSOR

May 5, 2000

4,008

0

• Jan 12, 2005

• #7

I do it like Gomer.

Install tubes, that is. :ohmy:

 

High Lord Gomer

Poked with Sticks

Sep 26, 1999

11,788

35

• Jan 12, 2005

• #8

I thought you meant leaving your nuts loose.

 

oldguy

Always Broken

Dec 26, 1999

9,411

0

• Jan 12, 2005

• #9

I have never left a nut inside (god posting that in reply to Gomer sounds bad) from fear of causing a puncture from the bulk inside.