Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
KIPS valve keep stripping
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="jdbrusch, post: 357585, member: 25926"] Sorry Joe I thought you were talking about the holes in the front of the gasket,the 1/4" hole as far as I can tell that you are describing are on the sides of the cyl.this is normal,forgive me if I am looking at the wrong ones still,The old grey matter(brain) is not what it use to be.Most likely they are this size to restrict coolant in this area and to direct it to the hotter area of the motor ,ie. the exhaust side,just a thought. Sorry Stan I am not very familiar with the 95 and up motor,but if can take the pipe off and remove the linkage from the govenor(kips) shaft and activate the rod manually you should see the valves move. I understand the kips rod on the kdx models that runs up from the crankcase is weak so make sure you support it with a wrench,it will break when you try to remove the nut,check the manual or past posts on this. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
KIPS valve keep stripping
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom