Reply to thread

Message: [QUOTE="Jaybird, post: 1045325, member: 22283"] I put new blades on, even though the others seemed fine. I also switched the blades to the other side. Same thing. It is like the right side is not in the same plane as the left side blade. Off just a few degrees, sort of leaving a higher bit of grass towards the middle. The whole bearing housing may be a bit bent within the deck itself. I'm going to remove the deck and start measuring for true. It may well have been something I did, as I have a few areas that has some unruly terrain and I have had it stuck in a ditch a time or two. I think I chucked out about $1600 for this POS. Oh well. (don't buy any Craftsman riders from Egay...as mine may be on there soon.) :) [/QUOTE]