CR_RIDER said:That would take longer to make the pvc driver than it would to do the fork rebuild...lol.But it is a good idea.There is one method when a guy cut half of the old fork seal off and used it as a seal driver???would this work pretty good?Please tell me what to look out for when im doing this (seal replacement)....
IndyMX said:I think it actually took all of 10 minutes to make my seal driver from that link.. It's really not hard, and it's extremely cheap.
do you have any pics of this being done?Ol'89r said:I second that. :cool: The pvc seal drivers work very well. :nod:
Another thing you can try is to take a strip of 35mm film or a thin feeler gauge with rounded edges and place it between the seal and fork leg. Run the strip around the inside of the seal being careful not to nick the seal. If there is dirt lodged in the seal it will remove the dirt and the seal may work again.
.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?