I took my rear shock off this week and serviced it.I noticed that my lower shock bushing had a lot of play in it. I bought a new bolt and bushing from Kawaski. The new bolt and bushing feel as sloppy as the old ones :bang: I measured the new bolt, it is .435", the new bushing I.D. is .475" I cant believe that a new bolt and bushing in this type of application would have .040" clearance. I called the dealer and had him double check the part numbers, he says I have the right ones. The old bolt and bushing have only .005" more clearance than the new ones after 17 years of pounding. This cant be right, I have almost twice the .028" service limit that is called out for the upper spherical bearing on the same shock :yikes: Anyone had experience with this matter?