Reply to thread

Message: [QUOTE="Woo, post: 1430967, member: 124305"] Hi everyone, this winter I am rebuilding my RM 125 2008 and during the reassembly, I faced a problem with steering stem. I installed new all balls bearings (bearing races are seated properly for sure) and when I reassembled the steering stem I noticed that the bearing tension nut doesn't have enough threads to thread on and same problem with the top nut. The pictures below will make it more clear what I am talking about. The steering stem shaft doesn't stick out enough from the frame. Base of the stem is not flush with the bottom triple, stem protrudes about 1-2 mm. Could you guys please check on RM's to see how the top nut looks? Is it flush with the stem or does the stem stick out from the nut? And is the base of the stem flush with the bottom of the lower triple? [/QUOTE]