Hey guys this is my first post on here and I've got a goooooood question. I've got an 02 rm125 that I put an 06 model crank in and at the time thought they were the same thing but the 06 rod looks to be about 10-12mm longer than the 02 rod was. Of course I've already put the bottem end back together before I noticed the difference. Does anybody know what piston I can use to give me the correct hight so I won't have to use a spacer plate between the cylinder and crankcase? I thought the 06 model piston might have a higher pin location to make up for the longer rod but the only oversize is .080, I'm on a 54.5mm bore (1st oversize) and don't really want to bore it that much. Any info will help, thanks.