I pulled my carb and cleaned it. The pilot and main jet are stock sized. I put it all together and now I need to start tuning.
Is there any best way to go about jetting.
shut to 1/4 throttle first, needle position for mid throttle first etc.
If I dial in the air screw first, and then change the needle position will it change where the air screw needs to be set.
I know this is a vague question. I've got a good grip on getting it set over time. just wondering if there's an easiest way to go about it.
Is there any best way to go about jetting.
shut to 1/4 throttle first, needle position for mid throttle first etc.
If I dial in the air screw first, and then change the needle position will it change where the air screw needs to be set.
I know this is a vague question. I've got a good grip on getting it set over time. just wondering if there's an easiest way to go about it.
