Reply to thread

Message

[QUOTE="MXer666, post: 1249117, member: 78842"]
Hey, im looking for an alternative to removing bearings inside my crankcase instead of heating it. I managed to get some of the bearings out from where i could punch them out with a relative sized socket and mallet but there are some bearing that cant be knocked out only pulled or fall out. Here ill show you what i mean:

[IMG]http://i168.photobucket.com/albums/u179/danthomas11/P1010008-1.jpg[/IMG]

here is a picure of my crankcase (excuse the mess) the two bearings there can only come out one way. Does anyone have and tips or tricks to getting them out? im not going to pry them out with a screwdriver and they dont want to come out on their own, i even tried asking nicely.

thanks for the help.

p.s if you want to know why i have the cases split is because i was mysteriously loosing tranny oil, running rich and it wouldnt idle too great. both crank seals were new so my bet was that i blew the crank gasket and i did. Im replacing the bearings cuz there original and the bike is old.(and its winter)
[/QUOTE]

Verification

Which ocean is California closest to?