Rodzilla
LIFETIME SPONSOR
- Jul 21, 1999
- 615
- 0
Been scanning the boards for float height adjustment on my 400RFS. Would like to improve the mileage. Most guys are at 10mm.
Working through the "BK" mod now trying to get the 1 sec. squirt. Put in James Deans reccomended jetting
165 main
EMN needle (3rd clip)
48 pilot
1.25 turns
When I had it apart I checked float height (9mm as per spec) but went out to 10 mm to keep the tubes clear and not waste gas.
Ran into a rider at the track who was at a full 13mm on his floats.
Good, bad or does it make a difference?
Working through the "BK" mod now trying to get the 1 sec. squirt. Put in James Deans reccomended jetting
165 main
EMN needle (3rd clip)
48 pilot
1.25 turns
When I had it apart I checked float height (9mm as per spec) but went out to 10 mm to keep the tubes clear and not waste gas.
Ran into a rider at the track who was at a full 13mm on his floats.
Good, bad or does it make a difference?