If its truly that new and you havent changed anything that might have caused it, there is no reason your dealer shouldnt call Kawasaki and ask for help. They are very good about goodwill warranty.
...Originally posted by GKKarns
I've ndone two kx65 bottom ends because of big end failure. Both bikes
were new 5-10 hrs on each. What we found was that the factory used too
much case sealant. The bead projected too far into the cases and as the rod
came around the oiling groove scraped the sealant off and filled up with it
not allowing any oil to get into the bearing. I have never heard of a cold
siezure of a roller bearing every true roller bearing siezure that I have seen
in industry was lack of lube or heat related or improper clearances.
The dealer did not cover either one of these bikes That is how I ended up
getting them to do. One was a 2000 and the other was a 2001. don't
get over zealous with the goo. Remember you can over do a good thing.
Hope this helps.
Garret
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?